Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Cedar Park, TX
Chimney repair in Cedar Park typically runs $350 – $1,500 depending on what’s failing, and most jobs are diagnosed during a routine sweep. Cedar Park’s housing stock, built mostly between the 1990s and today, gives us a very specific set of repair problems: corroded chase covers on factory-built units, cracked crowns on the few true masonry chimneys, and flashing failures where the pipe meets the roofline. Resolute Chimney Sweep works across 78613 and 78630, and we’ve handled Cedar Park chimneys since 2014. Call (877) 644-8036 to book a diagnostic inspection.
Why Cedar Park Homes Are Different
Cedar Park’s growth pattern means most of the city’s fireplaces are factory-built metal systems with chases, not traditional brick chimneys. These units behave differently than the older masonry stacks we see in Georgetown or Leander. The chase covers and caps on these systems are exposed, thin-gauge metal, and they take a beating from Cedar Park’s hail and hard freezes. When a builder-grade chase cover rusts through or a spark arrestor gets bent by hail, rain enters the chase and drains into the firebox. The firebox itself is usually fine, but the interior liner and damper start rusting, and that’s a repair bill that grows if you wait.
The second factor is HOA restrictions. A large share of Cedar Park homes sit in master-planned communities with strict rules about exterior modifications. Homeowners can’t always swap a corroded cap for a different style, because the HOA requires the replacement to match the original profile. That means we’re often sourcing specific model-compatible parts or fabricating a match, which is exactly the kind of work that separates a real chimney specialist from a handyman with a caulk gun.
The climate also shapes demand. Cedar Park’s fireplaces get concentrated use during the few hard freezes each winter, then sit idle through long, humid summers. Creosote that collected during a cold snap degrades and becomes more acidic in the heat, which accelerates metal corrosion. We also see wasp nests, bird debris, and moisture damage in flues that go eight months between fires. Most Cedar Park chimney issues are caught early with an annual sweep and a quick visual on the cap and chase.
Styles & brands we work with
Our Main Cedar Park Services
Two services account for most of the calls we handle in Cedar Park, and they’re closely related: a sweep is how we find problems, and dryer vent cleaning addresses the other combustion exhaust system in the home.
Chimney Sweep in Cedar Park
A sweep in Cedar Park clears soot and creosote from factory-built flues and direct-vent gas units, and includes a visual check of the cap, chase cover, damper, and accessible liner. In this market, the sweep often matters less for heavy creosote and more for what it turns up: a hailstorm-bent spark arrestor, a rusting chase cover, or moisture staining from a leaked cap. We carry professional-grade replacement components, so if the sweep finds a damaged cap, we can usually fix it on the spot. Full details: Chimney Sweep in Cedar Park.
Dryer Vent Cleaning in Cedar Park
Lint-clogged dryer vents are a fire hazard, and Cedar Park’s newer homes often route dryer exhaust through long, multi-story runs that trap more lint than a short wall vent. We clean the full run from dryer to exterior termination, verify airflow, and check that the termination cap opens and closes correctly. The same hail that dents chimney caps also jams dryer vent hoods, which is a problem we see regularly in the subdivisions off Lakeline and Ranch Trails. Dryer Vent Cleaning in Cedar Park.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Cedar Park
Chimney repair in Cedar Park is usually a chase-cover or cap problem on a factory-built unit, not a masonry rebuild. The hail and hard freezes that roll through the 183A corridor each year dent spark arrestors, crack chase covers, and expose the interior of the flue to rain. We repair these systems with professional-grade components, not hardware-store substitutes, and the right repair often extends the life of the entire fireplace by a decade. Since most Cedar Park fireplaces are used only during cold snaps, a damage issue can sit unnoticed for a full season – which is why we recommend an annual sweep that includes a cap and chase inspection. For a full breakdown of what our repair crews handle, see Chimney Repair.
Chimney Cap Installation
Signs you need it
Rain spots in the firebox, a missing or rusted cap, or visible gaps where the cap meets the flue mean water is getting in.
What it costs in Cedar Park
Chimney cap installation in Cedar Park runs $300 – $700 depending on cap size, material, and whether a custom bracket is needed for an HOA-approved profile.
How we do it
We measure the flue opening, verify the cap profile against what’s already on the roofline, and install a galvanized or stainless steel cap with a proper mechanical connection to the flue tile or pipe.
Chimney Cap Replacement
Signs you need it
A cap that’s bent by hail, rusted through, or missing sections can no longer keep rain and critters out of the flue.
What it costs in Cedar Park
Replacing a damaged chimney cap in Cedar Park typically runs $250 – $600 depending on the existing cap style and whether the mounting brackets are still sound.
How we do it
We remove the old cap, inspect the flue opening for rust or damage, and install a replacement that matches the original dimensions so HOA compliance and roofline clearance stay intact.
Chimney Liner Installation
Signs you need it
Flaking tile inside the flue, rust on the damper, visible gaps in the flue wall, or a failing draft during a fire all point to liner deterioration.
What it costs in Cedar Park
Chimney liner installation in Cedar Park runs $2,500 – $6,500 depending on liner diameter, flue height, and whether the chase on a factory-built unit needs additional work.
How we do it
We size a DuraFlex flexible liner to the existing flue, run it from the termination cap down to the appliance connection, insulate as required, and verify draft before handing the system back.
Chimney Flashing Repair
Signs you need it
A water stain on the ceiling near the fireplace, damp drywall around the chase, or visible gaps where the pipe meets the roofline mean the flashing has failed.
What it costs in Cedar Park
Flashing repair in Cedar Park runs $350 – $800 depending on whether we can reseal the existing metal or need to cut and install new flashing around the pipe.
How we do it
We route the roofline flashing, replace damaged sections with matched metal, and seal the union with a high-grade silicone or polyurethane sealant that holds up to Texas sun and freeze-thaw cycles.
What Chimney Repair Costs in Cedar Park
| Item | Typical range in Cedar Park |
|---|---|
| Chimney cap installation | $300 – $700 |
| Chimney cap replacement | $250 – $600 |
| Chimney liner installation | $2,500 – $6,500 |
| Flashing repair | $350 – $800 |
How much does chimney repair cost in Cedar Park?
Most Cedar Park chimney repairs fall between $350 and $1,500, with liner work running higher. The exact number depends on whether the problem is a cap, flashing, or liner. Call (877) 644-8036 for a fixed quote.
Do I need a new chimney cap after a hail storm?
Maybe. Hail bends spark arrestors and cracks chase covers, and a damaged cap lets rain into the flue. If you saw hail in Cedar Park this year, get the cap checked. We can tell you quickly whether it needs replacing.
Brands We Service in Cedar Park
We stock and install components from HeatShield, Gelco, Olympus Chimney, and Famco – the same professional-grade lines certified chimney specialists specify. That means a new cap, flashing, or liner isn’t a hardware-store substitute. Parts for common Cedar Park repairs are usually on the truck or available same week. Learn more about our brands.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Cedar Park, TX
| Service | Typical range in Cedar Park |
|---|---|
| Chimney sweep (factory-built) | $189 – $349 |
| Dryer vent cleaning | $149 – $299 |
| Chimney cap installation | $300 – $700 |
| Chimney cap replacement | $250 – $600 |
| Chimney liner installation | $2,500 – $6,500 |
| Chimney flashing repair | $350 – $800 |
| Chimney crown repair | $500 – $1,500 |
Two things push prices up in Cedar Park: HOA rules that require custom cap profiles or exact-match replacements, and two-story rooflines that make the chase harder to reach. Every quote is flat-price and confirmed before we start, so the number we give you is the number you pay.
Neighborhoods We Serve in Cedar Park
We work across Cedar Park, from the ranch-style streets of Forest Oaks to the master-planned communities off 1431 and the newer subdivisions around Lakeline Mall. Our crews are in the area weekly, so scheduling is usually straightforward regardless of which side of town you’re on.
- Forest Oaks
- Ranch at Brushy Creek
- Lakeline
- Buttercup Creek
- Twin Creeks
Service Area – Cities Near Cedar Park
Resolute Chimney Sweep serves Cedar Park and the surrounding communities along the 183A and 45 corridors. If you’re just outside the city, we regularly handle chimneys and dryer vents in Brushy Creek, TX, Anderson Mill, TX, Jollyville, TX, and Leander, TX. One call covers the whole area.
Serving Cedar Park, TX — Our Local Coverage Area
We’re based in the Cedar Park area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Cedar Park
We schedule Cedar Park work every week, and most inspections happen within five to ten business days. If a sweep turned up a leak during the rainy season, we can often move faster to keep water out of your firebox.
Most Cedar Park HOAs require that exterior cap or chase replacements match the original profile, but they don’t govern internal repairs like liner or flashing work. We’re familiar with the common requirements in local master-planned communities and can document the repair for your records.
Yes. We cover all of Cedar Park, including both ZIP codes and the newer communities off 1431 and Lakeline Boulevard. Most of our repair jobs start with a sweep and inspection in the same visit.
If your chimney or dryer vent needs attention in Cedar Park, call Resolute Chimney Sweep at (877) 644-8036 for a free estimate. We’ll give you a flat-price quote before any work begins, and the right material for the repair.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Cedar Park Customers Say
"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
— Rana Khalil"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
— Scott Fletcher"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Beatriz Guzman