Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Wells Branch, TX
Chimney repair in Wells Branch usually means one of two things: a rusted-out chase cover on a 30-year-old prefab fireplace, or a cracked flue tile letting heat reach the wood framing. We see both every month in this subdivision, along with caps that have gone missing after a spring storm. Resolute Chimney Sweep has served Wells Branch since 2014, and the work here follows the housing stock: factory-built fireplaces with short exterior flues that were installed in the late 1980s and early 1990s and are now well past their original service life. Call (877) 644-8036 when a sweep turns up something structural.
Why Wells Branch Homes Are Different
Wells Branch was built as a master-planned subdivision north of Austin, and the majority of homes went up between the late 1980s and mid-1990s. The fireplaces in these houses are almost all prefabricated units: factory-made metal fireboxes with double-wall flue pipe running up through a wood-framed chase, topped by a metal cap and a galvanized or aluminum chase cover. That is a different animal from a traditional masonry chimney. There is no brick flue to repair, but there is a metal system that has spent three decades in Central Texas sun, humidity, and the occasional hard freeze. Chase covers rust through at the seams. Flue caps loosen or blow off entirely. Wasps and birds find their way into the chase and build nests against the pipe. Because the same builder models repeat street after street, we can often spot a failed chase cover from the driveway before we even put a ladder up. The roofs here are shallow-pitched, which makes inspection straightforward, but the dry summer heat bakes the metal components until they fatigue. If your house has its original fireplace and has never had a sweep, the odds are good that something up top needs attention.
Styles & brands we work with
Our Main Wells Branch Services
Most calls we get from Wells Branch homeowners start with a sweep, and a meaningful share turn into repair once we’re on the roof and can see what the last 30 years have done. Dryer vents run through the same hot attics and share the same fire-safety stakes.
Chimney Sweep in Wells Branch
A sweep in Wells Branch starts with the prefab fireplace itself: we pull the logs or doors, vacuum the firebox, brush the flue pipe from the top down, and inspect the cap, chase cover, and pipe joints. Hardened creosote is common here because the fireplace sits idle through the long hot season and the residue sets up like varnish. We also check for bird nests and wasp hives in the chase, which are a spring and summer constant in this subdivision. One sweep a year is the right rhythm for a wood-burning fireplace in Wells Branch. Chimney Sweep in Wells Branch
Dryer Vent Cleaning in Wells Branch
Dryer vents in Wells Branch run through attics that bake at 140 degrees in summer, and the lint that builds up inside the pipe is essentially fire fuel. We clean the entire run from the dryer connection to the exterior termination, remove the accumulated lint with a rotary brush, and verify the outside damper opens and closes correctly. Two-story homes here mean longer vent runs than in older single-story neighborhoods, which increases the lint load and the fire risk if the vent has never been opened. Dryer Vent Cleaning in Wells Branch
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Wells Branch
Chimney repair in Wells Branch is largely about aging metal: chase covers that have rusted through at the seams, flue caps that have lifted off in a storm, and prefab flue sections that have warped or separated over 30 years of heat cycling. The hot, humid summers and occasional hard freeze accelerate that deterioration, and many homeowners do not notice until a sweep exposes the problem. When we find damage during a cleaning, we can usually correct it without referring you to another company. Our repair and installation work uses professional-grade brands like DuraFlex and HeatShield, and for Wells Branch homeowners that means the fix matches what certified chimney professionals specify, not a hardware-store substitute. You can read more about the full scope of what we repair on our Chimney Repair page.
Chimney Cap Installation
Signs you need it
You can see daylight from inside the fireplace where the cap should be blocking it, or birds have built a nest in the flue.
What it costs in Wells Branch
A new chimney cap installation in Wells Branch typically runs $185 to $380 depending on the flue size and the cap material.
How we do it
We measure the flue opening, select a cap that matches the pipe diameter, secure it to the flue with mechanical fasteners, and verify the spark arrestor mesh is intact.
Chimney Cap Replacement
Signs you need it
The existing cap is rusted through, has loose mesh, or was blown off the flue during a storm and is sitting in the yard or gone entirely.
What it costs in Wells Branch
Chimney cap replacement in Wells Branch runs $150 to $350, plus the cost of the new cap and any minor flue repair needed to seat it.
How we do it
We remove the old cap, clean the flue lip, install the replacement cap sized to the existing pipe, and add a weatherproof seal where the cap meets the flue.
Chimney Liner Installation
Signs you need it
The existing flue liner is cracked, rusted, or missing sections, and a camera inspection shows heat or exhaust reaching the chase framing or the home’s interior walls.
What it costs in Wells Branch
A Chimney Liner Installation in Wells Branch generally falls between $2,800 and $6,500 depending on flue length, access, and whether we’re installing a rigid or flexible system like DuraFlex.
How we do it
We run a camera inspection first, then install the correctly sized liner from the top down, insulate where required, and reconnect the appliance before testing the draft.
Chimney Crown Repair
Signs you need it
The crown or mortar cap shows cracking, spalling, or missing chunks, which lets water seep into the chase and damage the framing and flue pipe.
What it costs in Wells Branch
Crown repair in Wells Branch typically runs $350 to $900 depending on the size of the crown, the extent of the cracks, and whether the entire surface needs resurfacing.
How we do it
We clean the crown surface, fill cracks with a flexible sealant or resurface with a cementitious crown coat, and verify water no longer pools on the cap.
Chimney Flashing Repair
Signs you need it
There are water stains on the ceiling near the fireplace or the flashing has pulled away from the chase or roof after a storm, and the leak is clearly at the roof line.
What it costs in Wells Branch
Flashing repair in Wells Branch runs $250 to $700 depending on how much of the flashing needs to be replaced and the roof slope at the chase.
How we do it
We inspect the flashing and roof seal, remove the failed section, install new step or counter flashing, and seal the joints with weather-rated roofing sealant.
What Chimney Repair Costs in Wells Branch
| Item | Typical range in Wells Branch |
|---|---|
| Chimney cap replacement | $150 – $350 |
| Chimney cap installation | $185 – $380 |
| Chimney crown repair | $350 – $900 |
| Chimney flashing repair | $250 – $700 |
| Chimney liner installation | $2,800 – $6,500 |
Do I really need a new liner, or can the old one be patched?
If the liner has a single small crack and the surrounding metal is sound, a patch may be acceptable, but most Wells Branch prefab flues we open have multiple failure points after 30 years. We will show you the camera footage before recommending replacement.
How long does a chimney repair take in Wells Branch?
Cap replacement and flashing repair typically take one to two hours. Liner installation is usually a half-day to full-day job depending on flue length and roof access. We will give you a time estimate before we schedule. Call (877) 644-8036 for specifics.
Brands We Service in Wells Branch
Our repair work relies on professional-grade components from DuraFlex, HeatShield, and Gelco. We keep common cap sizes and liner connectors on the truck, and parts we do not stock arrive from our supplier within a few days. Our brands page shows the full range of what we carry and service.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Wells Branch, TX
| Service | Typical range in Wells Branch |
|---|---|
| Chimney sweep | $189 – $350 |
| Chimney cap replacement | $150 – $350 |
| Chimney cap installation | $185 – $380 |
| Chimney crown repair | $350 – $900 |
| Chimney flashing repair | $250 – $700 |
| Chimney liner installation | $2,800 – $6,500 |
| Dryer vent cleaning | $125 – $250 |
In Wells Branch, the biggest price drivers are flue length on two-story homes and the condition of 30-year-old chase covers. You get a flat-price quote before any work begins, and nothing is recommended without proof you can see for yourself.
Neighborhoods We Serve in Wells Branch
We cover the full 78728 ZIP code from Wells Branch Parkway down to the southern edge of the subdivision, including the two-story brick-veneer tracts that repeat through every street. Our typical response window in Wells Branch is two to four business days.
- Wells Branch North
- Wells Branch South
- Bratton Hill
- Willow Bend
Service Area – Cities Near Wells Branch
From Wells Branch we also travel to Windemere, TX, Pflugerville, TX, Anderson Mill, TX, and Jollyville, TX. Most of these neighborhoods share the same era of construction and the same prefab fireplace systems, so the inspection notes and repair approach carry over.
Serving Wells Branch, TX — Our Local Coverage Area
We’re based in the Wells Branch area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Wells Branch
Most repairs we schedule in Wells Branch can be completed within one to two weeks of the initial sweep, depending on the part needed. Cap replacements often happen the same week. Liner installations may take a little longer if the flue size is not standard. Call (877) 644-8036 and we will give you a real date.
Wells Branch is a master-planned community with active homeowner association oversight, and visible exterior changes like a chase cover replacement or cap style change may technically require approval depending on your section’s rules. The work itself is maintenance and does not require a City of Austin permit for standard repair. We will tell you if anything on your job might need a quick HOA sign-off.
We handle the sweep, the diagnosis, and the repair ourselves. The same technician who climbs your roof in Wells Branch and finds the rusted chase cover is the one who orders the replacement and comes back to install it. One call covers the sweep, the vent, and the repair.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Wells Branch Customers Say
"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
— Eduardo Reyes"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
— Rami Haddad"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."
— Emily Thompson